Beurer IH 58 - User Manual

Questions and Answers

M
Michelle WebbAug 10, 2025
What to do if my Beurer IH 58 Medical Equipment atomiser produces little to no aerosol?
- J
  Justin AdamsAug 11, 2025
  If your Beurer atomiser isn't producing enough aerosol, there might be a few reasons: * Ensure you have between 2 ml and 6 ml of medication in the atomiser. * Check the nozzle for any blockages and clean it if necessary by rinsing it out. If cleaning is required, carefully pierce the fine holes from the underside of the nozzle only. * Make sure that you are holding the atomiser vertically.
L
Lauren EscobarAug 15, 2025
What to do if my Beurer Medical Equipment atomiser produces no aerosol?
- J
  Jesus BestAug 16, 2025
  If your Beurer atomiser isn't producing aerosol, first check the medication level; it should be between 2 ml and 6 ml. Also, inspect the nozzle for blockages and clean it carefully, piercing the fine holes from the underside only. Ensure the atomiser is held vertically during use and that the medication fluid is suitable for nebulization, as prescribed by your doctor.
A
Ashley JacobsAug 22, 2025
Why should I replace the Beurer IH 58 Medical Equipment atomiser regularly?
- A
  alexandermalloryAug 22, 2025
  The atomiser should be replaced regularly to ensure an effective particle spectrum, as the nozzle hole must not exceed a specific diameter due to wear from mechanical and thermal stresses. Regular replacement is also recommended for hygiene reasons.
D
David AllenAug 28, 2025
Why does inhalation take longer when using a mask with Beurer Medical Equipment?
- A
  Amy PayneAug 28, 2025
  Inhalation takes longer with the mask because you breathe less medication per breath through the mask's holes compared to using a mouthpiece. The aerosol mixes with ambient air through these holes.
J
johnbeanSep 2, 2025
What to do if there is inhalation solution residue in my Beurer IH 58 atomiser?
- J
  Joshua GarciaSep 3, 2025
  This residue is normal due to technical reasons. Stop inhalation once the atomiser starts making a notably different sound.