Beurer IH 60 User Manual (English)

Questions and Answers:

A
Amy BoyerJul 28, 2025
How to fix Beurer IH 60 Medical Equipment atomiser that produces no aerosol?
- M
  Michael AnthonyJul 28, 2025
  If your Beurer Medical Equipment atomiser isn't producing enough aerosol, first, check the medication levels in the atomiser, ensuring it's between the minimum of 2 ml and the maximum of 6 ml. Next, inspect the nozzle for any blockages and clean it by rinsing if necessary, before trying the atomiser again. Make sure you are holding the atomiser vertically during use. Finally, confirm that you are using the medication fluid prescribed by your doctor, as unsuitable or overly viscous fluids can cause this issue.
K
Kathryn PenaAug 1, 2025
What to do if Beurer IH 60 Medical Equipment output is too low?
- P
  Paul SmithAug 1, 2025
  If the output of your Beurer Medical Equipment is too low, check for a kinked hose and resolve any kinks. Inspect the filter for clogs and clean or replace it if needed. Also, ensure you haven't added too much inhalation solution; adjust the amount accordingly.
A
Amanda JohnstonAug 6, 2025
How to fix a Beurer IH 60 atomiser that is not producing enough aerosol?
- L
  laurenreyesAug 6, 2025
  If your Beurer Medical Equipment atomiser produces no or too little aerosol, first ensure you have between 2 ml and 6 ml of medication in the atomiser. Inspect the nozzle for any blockages and clean it by rinsing if necessary, carefully piercing the fine holes from the underside only. Make sure you are holding the atomiser vertically. Finally, confirm that the medication fluid is suitable for nebulisation and prescribed by your doctor.
A
Andrew SummersAug 11, 2025
Why is there inhalation solution residue in my Beurer IH 60 Medical Equipment atomiser?
- H
  Holly WellsAug 11, 2025
  The presence of inhalation solution residue in the atomiser of your Beurer Medical Equipment is normal due to technical reasons. Stop inhalation once the atomiser starts to make a notably different sound.
L
Leslie FlowersAug 16, 2025
How to fix a Beurer IH 60 Medical Equipment atomiser that produces little aerosol?
- T
  Tara SmithAug 16, 2025
  If your Beurer Medical Equipment atomiser isn't producing enough aerosol, it could be due to several reasons. Ensure you have between 2 ml and 6 ml of medication in the atomiser. Check the nozzle for any blockages and clean it if necessary, carefully piercing the fine holes from the underside only. Also, make sure you're holding the atomiser vertically. Finally, the medication fluid should be prescribed by a doctor to ensure it is suitable for nebulisation and not too viscous.
J
Jonathan ChaseAug 21, 2025
Why is the output of my Beurer Medical Equipment too low?
- V
  vgrahamAug 22, 2025
  If the output of your Beurer Medical Equipment is too low, possible causes may include a kinked hose, a clogged filter, or too much inhalation solution.

Beurer IH 60 Specifications

General

Product color	Transparent
Product design	Tabletop
Built-in display	No
Indication light	Yes
Maximum pressure	0.5 bar
Nebulizer technology	-
Nebulization capacity	0.25 ml/min
AC input voltage	100-240 V
Power source type	Battery
AC input frequency	50-60 Hz
Product type	Nebulizer accessory kit
Quantity per pack	7 pc(s)
Brand compatibility	Beurer
Nebulizer accessory kit included	Air tube, Children's mask, Mouthpiece, Nose piece