SW-Stahl und Werkzeugvertriebs GmbH Tel. +49 (0) 2191 / 46438-0
F 56 essartS resukreveL ax +49 (0) 2191 / 46438-40
ed.lhatsws@ofni :liaM-E diehcsmeR 79824-D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
Art. 2200
Digital Clamp–on Multimeter
The meter is a completely portable LCD 3½ digital clamp meter. It has rugged design, is easy to hold
in operator’s hand and convenient to use.
1. Safety Information
1.1 Read the following safety information carefully before attempting to operate or service the meter.
1.2 To avoid damages to the instrument do not exceed the maximum limits of the input values show
in the technical specifications tables.
1.3 Never measure current while the test leads are inserted into the input jacks.
1.4 Do not use the meter or test leads if they look damaged. Use extreme caution when working
around bare conductors or bus bars.
1.5 Caution when working with voltages above 60VDC or 30VAC RMS. Such voltages pose a shock
hazard.
2. Operating Features
AC Current 0.01A to 600A
AC Voltage 1V to 450V
DC Voltage 1V to 600V
The meter display is a liquid crystal assembly providing a readable display in all light conditions.
The decimal point is automatically positioned, and the polarity sign (minus) is lighted for negative DC
measurement (plus is understood if no sign appears), so that the display is direct reading in units
selected at the rotary switch. Overrange measurements are indicated by blinking all but the MSD,
decimal point, and polarity sign (if negative). In addition the display includes a low battery indication.
If low battery is indicated, operator should replace the used battery with new one.
To Next Page
Loading...
Need help?
General
