BGW 150 - Power Mains Connections; Voltage Identification and Plug Type

04000
POWER
MAINS
CONNECTIONS
The
unit
should
be
plugged
in
only
when it
has
been
established
that
it
is
wired
for
the
correct
power
mains
voltage
and
after
all
other
connections
have
been
made.
The
mains
(AC
line)
voltage
is
indicated
on
the
label
on
the
rear
of
the
unit.
Products
supplied
for
use
in
the
United
States
and
Canada
are
factory
wired
for
120
volts.
Only
the
indicated
mains
voltage
should
be
used.
If
the
mains
voltage
must
be
changed,
see
POWER
MAINS
VOLTAGE
CONVERSION.
A
molded,
parallel
blade,
U-ground
plug
is
supplied.
This
connector
is
standard
in
the
United
States
and
Canada.
For
use
elsewhere,
the
plug
must
be
replaced
with
the
correct
connector.
The
color-code
of
the
cord is
as
follows.
HI
(switched
Leg)
-
Brown
(or
Black)
LO
(neutral
Leg)
-
Blue
(or
White)
EARTH
(chassis
ground)
-
Green
with
Yellow
tracer
(or
Green)