BH CORE - Troubleshooting

EN
USER MANUAL CORE
38
TROUBLESHOOTING
Description Error Observations
System overcurrent
Blinking
01
Check that the connection between the motor and the
controller is OK. If not, replace the controller.
System overcurrent
Blinking
02 Replace the controller.
TMM sensor
Blinking
03
Check that the connection between the TMM sensor
and the controller is OK. Check if the TMM sensor's
output is exceeding the normal range; it should be 0.1
V-3.5 V.
Error in the motor
Blinking
04 Check the motor's connector or the controller.
Error in the motor's
sensor
Blinking
05
Check that the connection between the motor and
the controller is OK. If the sensor inside the motor is
broken, replace the sensor or the motor with a new
one. Check that the connection between the motor's
cable and the controller is OK. If not, replace the
controller.
Low battery
Blinking
08 Check the battery level or replace it with a new one.
Blocked motor
Blinking
09 Motor stopped. Replace motor.
System overcurrent
Blinking
10
If there is faulty contact between the controller and the
motor's connector, replace it with a new one.
Overheating 11
If the temperature exceeds the set value, the current
will become gradually weaker.
Protection against
overheating
12
The controller stops on entering temperature
protection mode.
Communication
error
13 Check the cable and the connector.
Pedal error 14 Take your foot off the pedal and turn it back on.
Error in the speed
sensor
33
Check the speed sensor and magnet position in the
wheel.