Bialetti COURE - Common Problems & Solutions

4342
ENEN
9. Troubleshooting9. Troubleshooting
The coee maker does
not heat up.
The system does not
warn when the used
capsule drawer is full.
The coee maker does
not dispense coee.
The coee is cold.
The coee maker makes
too much noise.
Coee is dispensed
slowly.
The coee maker is
beeping / the LED is
blinking.
The used capsule has
not been ejected.
A) The coee maker is not
connected to the electric mains.
B) The coee maker is not
on.
L) The drawer has been
removed but not emptied
and the counting system
is reset.
C) The door is not closed
correctly.
D) The capsule is stuck.
E) The used capsule drawer
is full or it has not been
completely inserted.
F) There is no water in the
reservoir.
G) The ducts are clogged
with lime scale.
H) The coee maker has not
heated the water completely
before dispensing the beverage.
I) The cup is cold.
J) The boiler is partly clogged
with lime scale.
M) There is no water in the
reservoir.
K) Dispensing velocity depends
on the variety of coee that is
being used.
N) The door is not closed
properly.
O) The capsule drawer is not
inserted correctly.
P) The capsule is stuck to the
gasket.
A) Connect the coee maker
to the socket
B) Turn the coee maker on
by pressing the on/o button.
L) If the system allows so,
remove the drawer and
empty it. If the capsule is
stuck, turn the coee maker
o and then back on
to run a new verifi cation
cycle. Contact the nearest
service centre if the coee
maker does not expel the
capsule this way.
C) Close the door
D) See indications at paragraph
Blocked unit (page 39).
E) Empty the drawer and
make sure it is inserted
properly.
F) Fill the reservoir up.
G) Run a descaling cycle.
H) Wait for the touch-sensitive
button LED to turn green before
inserting a capsule.
I) Pre-heat the cup dispensing
hot water or using a cup
warmer.
J) Run a descaling cycle.
M) Fill the reservoir up.
K) Try with another capsule
or, if necessary, run a descaling
cycle. If it does not solve the
problem, contact the nearest
service centre.
N) Ensure that the door is
closed properly.
O) Insert the used capsule
drawer correctly, pushing it
down to the bottom of its
housing.
P) Repeat the brewing /
expulsion cycle; should it
not be successful, extract
the capsule with a pair of
tweezers.
Problem ProblemCauses CausesSolution Solution