EN
35
6. Coffee making
Before dispensing, check water
level in the tank (6), make sure the
light button (1) is green and pull
out the pod holder drawer (2).
Position the pod into the housing
of the pod holder drawer (2) and
insert into the machine body (7).
Place a cup onto the rack (3). Start
dispensing coffee by pressing the
apposite button (1). When coffee
reaches the required level in the
cup, stop dispensing by pressing
the light button (1) again. For each
following coffee, take out the pod
holder drawer (2), remove the
used pod and insert a new one.
During dispensing, the light button (1) will blink in
green. Wait until the light is steady, before removing
the pod holder drawer (2).
Press the light button (1) for more than 3 seconds to
switch the machine o.
To Next Page
Loading...
