Bianchi 1885 - Unpacking the Box; Getting the Front Wheel Ready

Assembly Manual Road Bike
4
I. Unpacking the box
Open up the special shipping box and remove the rectangular
protective cardboard on the rear wheel.
Take the wheel out of the box, followed by the saddle and
then the bike frame, which has the rear wheel already tted.
Remove the accessories box (Fig. 1)
Fig. 1
II. Getting the front wheel ready
Remove the two plastic protective covers on the hub of the
wheel
Open up the package of accessories and take out the quick
release skewer
Fig. 2 Quick release skewer
A
B
C
D
Loosen the acorn nut (B) on the quick release skewer and
remove the springs (C)
Insert the quick release skewer with the spring (D) into the
hub axle (Fig. 3 and 4)
Fig. 3 Fig. 4
From the other side replace the second spring (C) onto the
skewer and gently tighten the acorn nut (B)