6.2 System Outputs
Controller On Set active when the controller is powered on
System Fault Set active when any fault is present in the controller
Manual Mode Set active when the controller is in manual mode
Opening Set active when the actuator is opening
Closing Set active when the actuator is closing
Open Limit Set active when the actuator is fully open
Close Limit Set active when the actuator is fully closed
Open Solenoid Set active when the actuator is opening
Close Solenoid Set active when the actuator is closing
Aux Solenoid Set active when there is a common fault
Feedback Fault Set active when the feedback signal is in fault
Command Fault Set active when the command signal is in fault
Common Fault Set active when there is a signal indicating a common fault
Pump Output Set active when the pump is required to run
Pump Fault Set active when there is a signal indicating the pump is in fault
Overrun Fault Set active when the pump has run continuously beyond its maximum allowable time
Acc Press Fault Set active when the accumulator pressure signal is in fault
Low Press Fault Set active when the accumulator pressure is below the minimum allowable pressure
High Press Fault Set active when the accumulator pressure is above the maximum allowable pressure
Low Level Fault Set active when there is a signal indicating that there is a low oil level
High Temp Fault Set active when there is a signal indicating that there is high oil temperature
Low Supply Press Set active when the supply pressure is below the minimum allowable pressure
Supply Press Flt Set active when the supply pressure signal is in fault
To Next Page
Loading...