Why won't my BIG ASS FANS HAIKU L start?
If your fan won't start, verify that the fan is receiving power by checking the circuit breaker or fuse panel and the wall switch. Also, ensure the supply power is adequate and that all wires are securely connected, with the fan properly wired and grounded. Finally, confirm that the batteries are correctly installed in the remote.
What to do if my BIG ASS FANS HAIKU L Fan is noisy during operation?
If your fan is making noise during operation: * Bring the fan to a complete stop. * Gently turn the airfoils by hand to ensure no fan parts are rubbing on the hub during rotation. * Check all mounting and fan hardware, and tighten any loose components.
Why is my BIG ASS FANS HAIKU L Fan wobbling?
If your fan is wobbling, ensure all mounting hardware is secure and tight. Check that the sticker on each airfoil matches the corresponding sticker on the motor unit; if they don't, move the airfoils to the matching attachment points. Also, make sure all airfoils are aligned properly and securely fastened to the motor unit. If an airfoil is damaged, contact Customer Service, as airfoils must be replaced as a set.
How to reboot BIG ASS FANS HAIKU L Fan?
To reboot your fan, press and hold the fan On/Off button on the remote until the fan’s LED indicators start blinking. Within 30 seconds of the LEDs blinking, press the fan On/Off button again. The reboot is complete when the LEDs stop blinking.
What to do if the remote will not control the BIG ASS FANS HAIKU L/light?
If the remote isn't controlling the fan or light, remove and reinstall the fan’s light: 1. Turn off power to the fan at the wall switch or circuit breaker. 2. Remove the light from the bottom of the fan by twisting it counterclockwise. 3. Turn the power to the fan on. Wait 30 seconds, and then turn the power off again. 4. Reinstall the light, aligning the yellow arrow stickers on the bottom of the fan and light. Insert the light into the bottom of the fan and twist clockwise until you hear a click. 5. Turn the power to the fan on and test the fan/light operation using the remote. If the remote still does not work, contact Big Ass Fans Customer Service.
How to remove the wiring cover of BIG ASS FANS Fan?
To remove the fan’s wiring cover, use a long, thin object, like a small Allen wrench or pen tip, to press the recessed tab on the wiring cover. While pressing the tab, turn the cover counterclockwise and slide it down to remove it.
Why does my BIG ASS FANS Fan jerk upon startup?
The slight jerking forward and backward is normal and may happen occasionally upon startup and does not affect fan operation.
General| Energy Efficiency | Energy Star Certified |
|---|---|
| Number of Blades | 3 |
| Speed Settings | 7 |
| Blade Span/Diameter | 52 inches |
| Light Kit | Optional |
| Voltage | 120V |
| Smart Features | Works with Amazon Alexa, Google Assistant |
| Warranty | Limited Lifetime |
| Fan Type | Ceiling Fan |
Instructions to disconnect electrical power before commencing installation.
Mandatory adherence to National Electrical Code (NEC) and local regulations.
Guidance for attaching the mounting bracket to an approved outlet box.
Instructions for mounting the bracket to a concrete ceiling.
Instructions for mounting the bracket to a wood ceiling joist.
Connect fan wires to supply power, ensuring correct conductor separation.
Connect the earth/ground wire to the mounting bracket's ground screw.
Secure the safety cable to a suitable structural element in the building.
To Next Page
