What to do if my BIG ASS FANS Powerfoil X3.0 wobbles during operation?
Ensure the mounting structure is rigid enough to support the fan and that the fan isn't exposed to external air forces. If guy wires were installed, confirm they are properly installed.
How to fix a popping noise coming from my BIG ASS FANS Fan?
A popping noise can occur if the airfoils aren't tightened to the specified torque. Disconnect the fan from power, then tighten the airfoil fasteners to 29 ft·lb (39.3 N·m). If the popping continues, check that the airfoils are not contacting each other. If they are, further assistance may be needed.
What to do if my BIG ASS FANS Fan will not start?
Ensure all wires are securely connected and that the supply power is adequate and functional. If the fan still doesn't start, further assistance may be needed.
Why does my BIG ASS FANS Powerfoil X3.0 Fan motor make noise when speed is increased?
Audible high frequency carrier noise may indicate a stall condition. Check that motor currents are within limits. Refer to the technical specifications to confirm motor currents for your fan size.
How to change the direction of my BIG ASS FANS Powerfoil X3.0?
To change the fan direction, press the F/R button on the auxiliary controller.
General| Fan Type | Industrial Ceiling Fan |
|---|---|
| Number of Blades | 6 |
| Power Consumption | Varies by size and speed |
| Speed Control | Variable speed |
| Diameter | 8 ft, 10 ft, 12 ft, 14 ft, 16 ft, 18 ft, 20 ft, 24 ft |
| Motor | Gearless direct drive |
| Control System | Digital touchscreen controller |
| Mounting Options | Various mounting options available to suit different building structures |
| Controller | Digital touchscreen controller |
| Motor Type | Gearless direct drive |
| Mounting Type | Ceiling mount |
Technical details for Powerfoil X3.0 including fan diameter, motor size, and circuit requirements.
Technical details for Powerfoil X3.0 Plus including fan diameter, motor size, and circuit requirements.
Lists required tools and essential power supply/wiring guidelines for fan installation.
Details provided hardware for fan mounting, airfoils, and accessories.
Steps for preparing I-beams or angle irons according to beam flange width and span.
Procedures for attaching the fan unit, extension tube, safety cable, yoke, and airfoils.
Steps for mounting temperature sensors, wall controllers, and wiring the fan system.
Information on acceptable cable types, insulation, and shielding for VFD installations.
Guidelines for proper grounding, wire size, and handling input voltage irregularities.
Detailed wiring diagrams for various voltage and phase configurations, including line reactors and EMI filters.
How to start, stop, and switch control sources for the fan using the wall controller.
Explains the Winter, Summer, and Manual modes for optimizing fan efficiency and comfort.
Step-by-step guide to setting fan speeds and temperatures for different operating modes.
How to start, stop, and reverse fan rotation using the auxiliary controller.
Instructions for adjusting fan speed and navigating the controller display modes.
Explanation of error codes and procedures for resetting the VFD after a fault condition.
Annual and general maintenance procedures to ensure safe and efficient fan operation.
Lists error codes for E Series and M Series fans and provides corrective actions for common issues.
To Next Page
