Need help?Do you have a question about the BIG ASS FANS es6 and is the answer not in the manual?
General| Brand | BIG ASS FANS |
|---|---|
| Model | es6 |
| Category | Fan |
| Language | English |
Ensure the main power to the fan location is turned off at the breaker before installation.
This fan is not compatible with dimmer switches and must be wired to a standard on/off switch.
Collect all necessary tools required for the fan installation process before beginning.
Ensure the ceiling outlet box is rated for fan support and the mounting structure is secure.
Detailed instructions for drilling holes and installing anchors for concrete ceilings.
Connect the downrod to the motor bracket and secure with hardware, then connect wiring.
Attach the safety cable and ground wire lugs securely to the downrod assembly.
Slide the wiring cover and canopy down the downrod to prepare for mounting.
Insert the mounting ball and wedge onto the downrod, securing it properly.
Secure the mounting bracket to the ceiling structure using appropriate hardware.
Raise the fan assembly and align the mounting ball with the mounting bracket.
Connect the fan's wiring harness to the power supply according to the wiring diagram.
Install the fan stabilizer kit if purchased as an outdoor fan accessory.
Properly secure the safety cable to the mounting bracket or building structure as required.
Position and secure the canopy to the mounting bracket, ensuring wires are tucked.
Attach the six airfoils to the motor unit, ensuring they are seated and screws are tightened.
Align and twist the lower cover clockwise to lock it onto the bottom of the fan.
Plug in the light wiring harness and twist the light clockwise to lock it.
To Next Page