2.3. Caddy setup
2.3.1. Assembling and setting up the Caddy
Please make sure that the battery is installed in the caddy.
Place now the caddy on the lower end and pull the handle bar towards the top. If the side
arms do not move, the handle bar will not move; push the wheels gently away from the
frame if this occurs. The handle bar should now move easily towards the top. Place the
Caddy on its wheels. The side arms should be at a right angle to the frame and the wheels
should be parallel to each other. Close the fastening lever at the center. Now you can
assemble the front wheel. After you have fully insert the front wheel tilt the locking
device for the front wheel . The level should now be parralle to the caddy frame.
After that you can adjust the handle hight by opening the locking devices for the
telescope handle bar. Please lock them after wards by turing them to a parralle position to
the handle bar tube.
You should now be able to push and pull the caddy even when the caddy is not turned ON.
All parts should have a firm fit.
Now you can place the golf bag on the bag support tray and fix it with the straps. Please
ensure a proper seating of the golf bag and that the straps have a tied sit.
To Next Page
Loading...
