EasyManua.ls Logo

Big Max Nano - Rechargeable Battery Pack Management; Rechargeable Battery Charging Process

Big Max Nano
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3. Rechargeable battery pack, storage and care
Remember to recharge the rechargeable battery pack prior to your next game. When the Caddy
will not be in use for more a long time e.g winter brake, we recommend that you charge the
battery only 50% and than disconnect the charger and remove the battery from the
caddyhe caddy during that time. The combination of the charger and the battery allow up to
500 load cycles.
Please make sure that the charger is not connected when you start with you caddy. Remove
the charger from the power outlet when not in use.
Use only the charger which is build for your battery. If you
exchange the charger it may cause defects with can not be forseen.
3.1. The charging process
Plug the charger into a suitable mains supply outlet. Yet the LED1 and LED2 will go
to red. While LED2 will be blinking after the initial process is completed the LED1
will stay on to indicat that the charger is connected to the wall outlet.
Attach the charger connector to the rechargeable battery pack. The LED2 will show a
constant red when charging and turn green after charging is completed
If the battery is fully recharged, the LED2 will be green. The charger turned into
trickle charge mode. In this mode, the charger can remain connected for a longer time.
LED1 LED2
Charger connector

Related product manuals