BIG TREE TECH KNOMI - Power Supply Connection

GND
5~24V
8
WWW.BIGTREE-TECH.COM
INSTALL KNOMI TO STEALTHBURNER
ROUTING THE CABLE
As illustrated in the diagram, pass the cable of
KNOMI through the designated cable slot on the
printed part and direct it towards the rear of the
turbofan.
POWER SUPPLY
KNOMI is compatible with a voltage
range of 5-24V.
If you are not using an EBB SB 0000 CAN
or a similar one, route the cable to the
position shown in the provided image, and
then connect it to your motherboard or an
alternative power source.