KNOMI DISCONNECTED
If KNOMI is displaying this interface, it means that KNOMI is disconnected from the printer.
This may be caused by the following problems:
1. You have modified the Wi-Fi name or password, causing KNOMI and the printer to be in
different network states. To resolve this, press and hold the BOOT button on the side of
KNOMI for 5 seconds to enter the "HELLO" interface. From there, you can reconfigure the
network connection.
2. The printer has a network failure and cannot establish a network connection with KNOMI.
To resolve this, try restarting your 3D printer.
3
CONFIGURING WIFI
To Next Page
Loading...
