BIGREP ONE GENERATION 3 - III. Software; III-A Overview

III. Soware BigRep
III Soware
III-A Overview
* 2016-04-07
› Linux System incl. Pronterface preinstalled
› Printer is based on smoothieware [http://smoothieware.org/]
› Config File is part of the firmware and defines all settings of the BigRep ONE
› Pronterface and BigRep GUI preinstalled
› With Pronterface the user can operate the printer
› Optional: BigRep GUI
› Slicing soware is not part of the printer. Recommended Slicing Soware:
simplify3d. Presettings at BigRep Customer/Reseller Portal.
III-A 1/1