BIGREP ONE GENERATION 3 - Page 40

III. Soware BigRep
M5 Stops the spindle Only if spindle module is
enabled.
M5
M17 Enable stepper motors
M17
M18 Disable stepper motors
M18
M20 List SD card files
M20
M21 Initialize the SD card. This does nothing in
Smoothie but is kept for compatibility
M21
M23 Select a file
M23 le.gcode
M24 Start or resume SD card print
M24
M25 Pause SD card print
M25
M26 Abort a SD card print
M26
M27 Report print progress
M27
M28 Begin write to SD card. Use M29 to indicate
end of file.
M28 le.gcode
M29 End write to SD card. Used to end file write
started with M28.
M29
M30 Delete a file on the SD card
M30 le.gcode
M32 Select a file, and start playing it
M32 le.gcode
M82 Set absolute mode for extruder only
M82
M83 Set relative mode for extruder only
M83
M84 Disable steppers
M84
M92 Set axis steps per mm
M92 E200
M104 Set Extruder Temperature - S<tempera-
ture>
M104 S190
M105 Read current temp
M105
M106 Turn fan ON
M106
M107 Turn fan OFF
M107
M109 Set Extruder Temperature and Wait -
S<temperature>
M109 S190
M110 Set current line number -N<line number>
M110 N123
M112 Halt all operations, turn o heaters, go
into Halt state
M114 Show current position of all axes, XYZ will
be the last requested position, whereas
ABC is actual current position of the actu-
ators
M114
III-F 4/8