BIGREP ONE GENERATION 3 - Page 41

III. Soware BigRep
M117 Display message on LCD, blank message
will clear it
M117 hello world
or M117
M119 Show limit switch status
M119
M120 "Push" the current feed-rate and seek-rate
so that another one can be temporarily
used, then the current one can be restored
M120
M121 "Pop" the current feed-rate and seek-rate,
see M120
M121
M140 Set Bed Temperature - S<temperature>
M140 S55
M190 Set Bed Temperature and Wait - S<tempe-
rature>
M190 S55
M200 Set E units for volumetric extrusion -
D<filament diameter> set to 0 to disable
volumetric extrusion
M200 D3.0
M203 Set maximum feedrate your machine can
sustain <mm/sec>
M203 X100 Y100
Z100 E10
M204 S<acceleration> Set acceleration in mm/
sec^2 Z<acceleration> NB Z only applies
to Z only moves E<nnn> Set extruder only
move acceleration
M204 S1000 Z100
E500
M205 X<junction deviation> Z<z junction de-
viation> S<minimum planner speed>, Z
junction deviation only applies to z only
moves, 0 disables junction deviation for Z,
-1 uses global junction deviation
M205 X0.05 S30.0
M206 Set homing osets
M206 X10 Y3 Z0.5
M207 set retract length S[positive mm] F[feed-
rate mm/min] Z[additional zli/hop] Q[zli
feedrate mm/min]
M207 S4 F30 Z1
M208 set retract recover length S[positive mm
surplus to the M207S*] F[feedrate mm/
min]
M208 S0 F8
M220 S<factor in percent>- set speed factor
override percentage
M220 S50
M221 S<flow rate factor in percent>- set flow
rate factor override percentage for current
extruder
M221 S50
III-F 5/8