IV. Setup BigRep
c. Use a li truck and li the printer from the upper side:
d. Done
Option 2
Use the front side of the box as a ramp and pull out the printer by hand. The
front side comes with preassembled angle brackets.
If you choose Option 2, it is not necessary to take away the sides and the lid
of the box.
a. Make sure that all 4 brakes are loosen
b. Lay down the ramp at the front side of the box, with the flat (outside)
side up. Make sure that there is no space between box and ramp.
c. Now gently pull out the printer straight out of the box with at least two
persons.
IV-C 3/5
To Next Page
Loading...
