IV. Setup BigRep
IV-F Electric Setup
* 2016-04-07
If there is no standardized power network a local electrician should always do
the electric setup!
› Printer configuration: 200-240V, needed: at least 200V & 16 Amp
› Preassembled Schuko Plug can be replaced
› Clients in the US have to make sure to provide a proper power supply
› In most countries there has to be a local electrician during the setup
› Always make sure that the client is informed about the power supply
needed and a local electrician is onside during start of the setup
IV-F 1/1
To Next Page
Loading...
