IV. Setup BigRep
IV-G Assembling
* 2016-04-07
Spooler cabinet
Note:
If there is no standardized power network a local electrician should always do the
electric setup (see 4.5).
Steps:
1. Take the spool cabinet from the printing bed.
2. Use the eight screws you will find in the accessories box .
3. Assemble the spool cabinet at the back wall of the printer above the control
unit.
Table / Bed
The screws at the frame of the table have to be loosen aer transportation in
order to ensure expansion while heated:
1. Unscrew all 8 Torx (T20) by 2-3 turns.
Note:
If possible a second person should hold the cabinet while the first person
screws in the 7 (2x M8x30. 5xM8x40) screws.
IMPORTANT: Use gloves while working with these screws as they are lubricated.
Fuse
Steps:
Plug in Fuse UPS
1. Open control unit.
2. Take Fuse next to USP and plug it in .
3. Close control unit.
Extruder
Important:
Machine has to be switched o during assembling the extruders!
Assemble both extruders at T0 and T1:
1. Take extruders out of accessories box.
2. Put Extruder T0 to the le bracket (with the pins).
3. Use the preassembled screw at the front to attach the extruder to the
bracket.
4. Connect both marked plugs to the back of the extruder.
IV-G 1/1
To Next Page
Loading...
