BIGREP ONE GENERATION 3 - I-B Table; Bed

I. Mechanics BigRep
I-B Table / Bed
* 2016-04-07
Overview
› BigRep ONE comes with a heated (aluminum) printing bed, incl. polyamide
printing tape which can be replaced.
› The heated bed and polyimide tape ensures that the first layers stick to the
bed.
› The attachment of the bed is directly mounted to the frame.
› The bed is heated by two heating mats, glued to the rear side of the table.
› The bed is float mounted to assure expansion while heated.
› The height of the bed can be adjusted – but this is only necessary once
during the setup and should not be done by the customer.
› The adjustment of the bed is important to ensure correct leveling proce-
dure.
› The bed can be heated up to 85°, 60° is regular printing temperature.
I-B 1/1