BIGREP ONE GENERATION 3 - Page 82

VI. Appendix BigRep
Visual Inspection BigRep THEONE
S/N Printer: ______________________________________________
S/N Control Unit: ______________________________________________
S/N Extruder 1: ______________________________________________
S/N Extruder 2: ______________________________________________
GUI Version: ______________________________________________
1 General Visual Inspection
 Frame
o Anodized?
o No: scratches, cracks etc?
 Frame Cover
o Correct Colour?
o No: scratches, cracks etc?
o Detent Edge Disc: correct position?
o Washers at both sides?
 Dragchain
o Proper wiring within dragchain?
o All strain-relief existing?
o All dragchains roper fixed ?
 Bed
o No scratches?
o Polyimide film (orange tape) proper glued, no bubbles?
o Loosen screws at the side of the bed?
 Control Unit
o Both identification plates existing?
 Spool Holder
o No scratches?
o Correct ?
o Free movement of drivers roller?
 Back Wall
o No scratches?
VI-B 3/4