Bigrep – Shipping/requirements/Unpacking
page 2/2
5. Setup
a. Setup and introduction will take 2 business days.
Please fill in a date that would suit your company:
Possible dates:
6. Set-up site / Requirements
(printer size - Height: 200cm Length: 230cm Width: 180cm)
• Ensure that the floor can bear the weight of 500 kg!
• The machine may not be accessible to unauthorized personal especially
• Make sure that the floor is level.
• Ensure sufficient ceiling clearance (minimum 1 m from unit to ceiling).
after initiation of the print process.
Ensure for a good printing environment at printer location:
• Avoid high humidity
• The temperature in the operating environment may not exceed 40°C / 104°F
• Avoid strong drafts during the printing process
• Avoid direct sunlight on the machine
• Do not install the machine on a floor that could be subject to vibrations
• Avoid dusty operating environments (e.g. cutting dust)
7. Unpacking and Moving BigRep
8. Additional Information
Filament and Spare Parts: www.bigrep.com/shop
Moving Box: The box can be moved with a standard hand pallet truck
Moving Printer: The printer comes on wheels and can easily be moved after unpacking
It is not recommended to do the unpacking by your own – our team is more
than happy to support you during the entire setup ! In case you have to do
the unpacking by your own please contact BigRep Customer Experience!
Seminars and Academy: please write an email to academy@bigrep.com
Customer Portal: If you do not have a login to your personal customer portal,
including FAQs and ticketing system, please send us an email
(support@bigrep.com)
To Next Page
Loading...
