Bikal CBC101w - Led Display Control

To Next Page

To Previous Page

Fixed Wireless/Wired IP Camera

3.9. LED Display Control

The IP CAM provides the Led Display Control function, you can enable or disable the

led display/indication on the front panel of the IP cam device. The related settings are

explained below:

1. Normal led display - select this to enable the status LED and ethernet LED display.

2. Turn off led display always - select this to disable the status LED and ethernet LED

display.

3. Turn off LED display after network connected - select this then the LED will display

when the Internet connection has some problem, the LED display will be off when

the Internet connection is successful.

Figure 3-14: Led Control settings page