25
Battery charge level display
Please ensure that while switching on the bicy-
cle as well as two seconds subsequent to this,
you do not place a foot on either of the pedals.
The sensor in the motor is adjusted
afresh every time it is switched on. It should
not be subjected to any force during these
two seconds.
Display (after
2 seconds)
Battery charge
3 LEDs lit *** 70-100 %
2 LEDs lit ** 40-70 %
1 LED lit * 10-40 %
1 LED slowly
flashing °
< 10%
Now you will
start to notice
a slight loss of
performance.
1 LED quickly
flashing °
- 0%
The system will
soon switch
itself off.
2 sec.
Automatic switch off
If your FLYER does not move
for ten minutes after stopping,
the system turns off automatically. If you
would like to ride with support once more,
you have to press the “Power” button on
the screen once again.
To Next Page
Loading...