Biketec AG Flyer - Page 43

39
4. Open the safety on the handlebar stem
(black ring), at the bottom end, by turning it
anti-clockwise. Then press the lever down
und klappen Sie den Lenker-Vorbau auf die re-
chte Seite des Rades.
and fold the handlebar stem to the right side
of the bike.
2
1
5. If it is still out, fold the kickstand of your
FLYER back in.
6. First open the safety on the frame joint and
then push the lock lever back.
Then you can fold the front part of the frame
to the left.
1
2
8. This is how your FLYER should look in cor-
rectly folded position:
7. Move the front and rear part of the frame to-
gether up to the point where the magnet holds
them in place.