Billi Quadra Plus - Instructions; Timeswitch ON;OFF; Override ON;OFF; Locked ON;OFF

6
User guide
Billi Quadra & Quadra Plus.
Instructions
—Normal Display Current status may be displayed as follows
TIMESWITCH ON/OFF Indicates the Quadra has been switched ON or OFF by the inbuilt
time switch control. During OFF mode, the dispenser icons are
o and give a brief orange flash once every 10 seconds.
OVERRIDE ON/OFF The Quadra can be manually turned ON or OFF by pressing the
ON/OFF button. The status remains as selected for a period
of 2 hours, after which it returns to automatic ON/OFF control.
LOCKED ON/OFF The ON/OFF status can be permanently locked ON or OFF.
Use ON if 24 hour, 7 days a week service is required; or OFF if
user is going away for an extended period. To activate or deactivate:
press the ON/OFF button and hold down until the required status
is displayed.
SAFETY SWITCH The child proof safety Switch mode has been activated. To set,
refer to Options, page 7.
STANDBY A period of non-use has elapsed and the Quadra has switched to
the energy saving standby mode.
—Daylight saving
Time adjustment for daylight saving is
made by pressing either the START or
FINISH buttons at the beginning or end
of daylight saving.
—Menu
To access the menu, press the SELECT
button. The menu functions are:
– To move the highlighted cursor, press
the or buttons.
– To activate the highlighted cursor,
press SELECT.
– To return to previous screen, press BACK.
—Setting time and date
Screen shows currently set time, day and date.
– Press or buttons to move the highlighted
cursor.
– Press SELECT to activate. The highlighted
item flashes.
– When flashing, press or to change
setting.
– Press SELECT. Highlighted cursor stops
flashing. Cursor automatically advances
to next setting. Repeat above activation
procedure.
– Press BACK once to return to previous
screen or twice to return to normal display.
—Setting time switch
Screen shows active and non-active days.
Turn-on and Turn-o times for active days
are displayed.
– Press or buttons to move the
highlighted cursor.
– Press SELECT to activate. The highlighted
item flashes.
– When flashing, press or to change setting.
– Press SELECT to confirm and advance
to next setting. Repeat above activation
procedure.
– Press BACK twice to return to
normal display.