Filter removal and
replacement instructions
Important note: Please ensure you remove the
foam packing under the filter before installing.
1. Press or hold the “ON/OFF” Button until
the lights in the tap turn OFF.
2. Hold filter and pull towards you slowly.
The top of the filter is in a hinged cradle
assembly. It should stop after approximately
30 degrees of travel.
3. The filter can now be released from the
holding cradle by pulling down on the filter.
4. Take care not to spill water in the base of
the tray. If so wipe gently with absorbent
paper towel.
5. Install new filter(s) into the same location
by pushing all the way up into the cradle.
6. Push filter(s) forward until perpendicular
to the base and locked in place.
7. Unit will now begin an automatic flush cycle.
Tap lights will flash orange and water will
dispense from the cold side of the tap.
8. When the flush cycles finishes, the unit
will automatically reset and return to the
previous operating mode. It is normal to
see the tap lights displaying a solid red light
and a flashing blue light. This indicates that
the chilled water is currently being chilled
and should return to a solid blue light
within 5 minutes.
9. Check for any leaks from around the filter,
hosing or pipeworks.
10. Replace the front cover.
9
User guide
Billi Quadra & Quadra Plus.
To Next Page
Loading...
