Part No 501505 18 F041513A
BC2600 Hydro Series Brush Cutter Owner’s Manual
TROUBLESHOOTING
Throttle is set to Slow/Stop position.
Move throttle to fast position.
Old or contaminated gasoline.
Drain gas tank and fill with fresh gasoline.
Spark plug wire disconnected.
Clean or replace air cleaner.
Starter does not turn.
(Electric start only)
Charge or replace battery.
Battery cable disconnected or corroded.
Clean and secure battery terminals.
Defective starter switch or wiring harness.
Replace starter switch or wiring harness.
Blade drive cable tension incorrect.
Adjust blade drive cable tension.
Will not cut or cutting performance is poor.
Sharpen or replace blade.
Excessive debris built up on or blocking
blade.
Clear debris from blade area.
Blade loose or out of balance.
Check blade for tightness. Rebalance if
necessary.
Check engine mounting bolts.
Replace blade drive belt.
Clutch cable tension too low.
Replace spring on idler arm.
Replace worn or defective clutch assembly
parts.
Blade brake will not engage.
Inadequate slack in clutch cable.
Replace clutch/brake assembly.
Transaxle will not engage.
Clutch lever not engaging clutch.
Transaxle will not disengage.
Clutch cable out of adjustment.
Engine will not turn over.
Contact an authorized servicing dealer for
your engine.