Part No 501505 7 F041513A
BC2600 Hydro Series Brush Cutter Owner’s Manual
OPERATION
OPERATOR CONTROLS
The operator’s station is at the rear of the machine between the handlebars. The operator should STAND in a position to
allow both handlebars to be grasped firmly and which allows sufficient leverage to steer the machine. Operator’s controls are
shown below.
Operator Control Locations
1 Blade Clutch Lever 5 Start Switch (Electric only)
2 Forward Lever 6 Pull Starter
3 Reverse Lever 7 Choke
4 Throttle
STARTING
CHECK engine oil level before operating machine.
1. Place equipment on a level, firm surface that is free of rocks or other debris.
2. Place throttle in Fast position.
Throttle
3. Pull choke out (Honda engine only).
Choke
To Next Page
Loading...
