Attach Head Pillow
Figure 17: Locate the slots at the top of the
Table Bed just beneath the Handhold as shown.
Insert the two pointed ends on the back of the
Head Pillow into the slot of the Table Bed and
pull through from the back of the Table Bed to
secure the pillow into position.
Figure 17
Attach Angle Tether
The tether will come pre-assembled to the
A-Frame.
Figure 16: Unfold the adjustable tether and
clip it to the U-Bar on the underside of the
Table Bed.
Slide the buckle to lengthen or shorten the
strap depending on your desired maximum
angle of inversion.
Figure 16
ATTACH ANGLE TETHER
& HEAD PILLOW
LENGTHEN
SHORTEN
STEP 5
11
To Next Page
Loading...
