BEFORE FIRST USE
Carefully remove all packaging and assemble the product following the setup & operating
instructions below.
SETUP INSTRUCTIONS
Head Unit - Fan Blade & Protection Grill Assembly
•
Place the rear grill (6) on the motor housing (8)
•
Secure it using the grill nut (5) - turn clockwise to tighten by hand, do not over tighten
•
Push the fan blade (4) onto the motor drive shaft aligning it carefully
•
Secure the fan blade (4) with the fan lock nut (3)
•
Assemble the front grill (2) to the rear grill (6), using the grill band (1) to secure it
Base Assembly - Telescopic Tube to Base
•
Place the base (12) on the floor
•
Insert the telescopic tube (10) into the recess on the top of the base
•
Secure using the bolt (13) provided
Head Unit to Base Assembly
• Pull up the telescopic tube (10) and tighten the tube lock nut (11).
Caution: The height adjustment knob (11) must be fully tightened before assembling the
motor section to the pedestal stand assembly.
• Fit the head unit to the base assembly and tighten the screw knob.
Caution: The screw knob must be fully tightened before the fan is switched on.
To Next Page
Loading...
