The pump inlet pressure should nominally be 1 bar [15 psi] higher.
ATEX special conditions for safe use:
Earth connection, Binks Part No. 0114-011798
Attach flexible hoses to all connections. Connect a regulated air supply to the air connection.
Mount the pump securely and position the pump at a convenient height to allow for maintenance.
Set the air regulator pressure to give the desired fluid flow.
The pump must be earthed at all times. A resistance <1Ω when measuring with an ohm-meter at the
earth point
Fluid Regulator Air Pilot
Set the pump speed to a slow cycle rate and prime the pump to remove any air before increasing
pressure.
This product should be flushed with a suitable compatible solvent prior to use.
77-3207-R1.7
6/16
www.carlisleft.com
To Next Page
Loading...
