925-0290 Rev A 9
6.0 EXTERNAL VIEW LED
PROCAP I models include an external view LED. PROCAP I X models do not have an external view LED.
This LED provides an externally visible status indication for the PROCAP I. When this LED is flashing, it
indicates a normal Uncovered condition. When this LED is ON steady, it indicates a Covered condition.
When this LED is OFF, it indicates a power failure or fault condition. This external LED is affected by any
time delay set for the relay contacts.
7.0 TIME DELAY
The PROCAP I has two single turn adjustable time delay potentiometers. The Delay potentiometer labeled
UNCVR is for applying a time delay on going from a covered indication to an uncovered indication.
The Delay potentiometer labeled CVR is for applying a time delay on going from an uncovered indication
to an covered indication. Each potentiometer can be set for a time delay of up to approximately 30 sec-
onds. This time delay affects the relay contacts and external LED only. The internal Covered LED
will immediately respond to a change in covered or uncovered condition regardless of the time delay set-
ting.
Minimum time delay is when the DELAY potentiometers are set fully counter-clockwise. (Refer to the Fig-
ure below for the location of the DELAY potentiometers.) Maximum time delay is with the DELAY potenti-
ometer set fully clockwise.
DELAY
COARSE FINE
INTERNAL
COVERED
LED
EXTERNAL
COVERED LED
COVEREDUNCOVERED
To Next Page
Loading...