Bio Compression Systems SC-2004-OC - Putting Garments On; Operating the Device; Cleaning and Disinfection Procedures; Pump and Tubing Cleaning

CAUTION: In case of power failure, the Sequenal Circulator shall automacally power
o. The pump does not have a baery backup nor mer memory. Once power is re-
stored, the Sequenal Circulator will need to be powered on in order to resume treat-
ment. User must keep apprised of alloed treatment me.
GENERAL GUIDELINES FOR TREATMENT
Physician must prescribe sengs for use with this device. The general guidelines below
are for informaonal purposes only and should not replace sengs provided by
physician. 60mmHg is an eecve seng for many paents. Physician must provide
paent’s sengs.
The presence of broc ssue may require a pressure of 80mmHg in order to soen the
broc ssue and achieve reducon. Once ssue soens, compression may be reduced
to 60mmHg, if determined by physician
Paents with a history of Congesve Heart Failure (CHF), which is controlled by
medicaon, should never be in a at posion while using the Sequenal Circulator. These
paents should be in a reclined posion with their legs elevated during treatment. It is
suggested that treatment regimens be divided into two daily 30-minute treatments.
Paents with a history of Deep Vein Thrombosis (DVT), with or without a lter, may
require less compression pressure, 40mmHG is generally tolerable but must be
prescribed by a physician. Paents with a lter may need to divide treatment into two
daily 30-minute sessions. It is suggested that the provider obtain a Negave Doppler
Study from the physician for their records.
MAINTENANCE AND STORAGE
Exterior Pump Case Cleaning instrucons:
1. Clean the exterior case and tubing with a damp (not wet) cloth using mild soap and
water soluon once per month
WARNING!
 Only an authorized technician may open the pump
 Before cleaning, unplug power cord from electrical outlet
GARMENT CLEANING/DISINFECTING INSTRUCTIONS:
Disconnect garment from device.
2. Open garment to expose all sides either by separang Velcro type hook and loop or
by unzipping (depending on type of garment).
WARNING!
 Do not allow liquids to enter pump, as this can present an electrical hazard
 Always allow the pump to dry before using
 Do not use bleach on the pump
3. Cleaning soluon should consist of 1/3 cup of laundry detergent per 1 gallon of
warm tap water. Use either a large sink or plasc tub able to hold enough soluon
(depending on size and quanty of garments) to completely submerge the garment
leaving the latch connector bars out of the water.