System Startup | 43
System Startup
To turn on the ELx800, press the on/off switch on the right side of the reader’s base. The
ELx800 will perform a System Test, displaying the screens shown below until initialization
is complete. During this period, all keys are inactive.
If the instrument fails the System Test, a chirp will sound, and an error code will display.
• Refer to
System Self-Test and Checksum Test in Chapter 4 for more
information.
• Refer to
Chapter 6, Troubleshooting and Error Codes to interpret error codes,
and
Chapter 1, Introduction for information on contacting Bio-Tek Instruments’
Technical Assistance Center (TAC).
P o we r u p Sequence Vx.x x
I n it i a l izing...
B i o- T e k Ins truments
S y st e m Self-Test
ELx800 Operator’s Manual
To Next Page