Biocomp GRADIENT MASTER 108 - Table of Contents

TABLE OF CONTENTS
SECTION 1. INTRODUCTION 4
Warranty and service 4
Maintenance 4
Electrical surge protection 4
Goods damaged in transit 4
SECTION 2. SPECIFICATIONS 5
SECTION 3. PARTS DIAGRAMS 6
SECTION 4. ORDERING INFORMATION 7
A. The Gradient Master Gradient Forming System 7
B. The Western Roller Blot Development System 8
C. Magnabase Blotting Bottles 8
SECTION 5. INSTRUMENT SET-UP 9
SECTION 6. PROGRAMMING INSTRUCTIONS 10
A. Levelling the plate 10
B. Recalling a gradient from memory and running it 10
C. Preparing and capping the gradient tubes 11
D. Forming the gradients 12
E. Repeated use of the same gradient 12
F. Developing your own gradient run parameters 13
G. Programming the device. 14
H. Entering gradient run parameters acquired elsewhere 17
I. Fixed angle and vertical rotors:Using the adjustable marker
block and quick-seal tubes. 17
SECTION 7. INTERNET PROGRAMMING INSTRUCTIONS 18
Entering new system software or run parameters 18
SECTION 8. NOTES AND HELPFUL HINTS 21
A. General 21
B. Gradients 21
SECTION 9. TROUBLESHOOTING 21
GRADIENT RUN PARAMETERS LAST PAGES
2