3.2 GRADIENT FORMING ATTACHMENT
!
SECTION 4. ORDERING INFORMATION
The Gradient Station™ gradient forming and fractionation system.
4.1 Base Unit: Cat No. 153-001 90-120VAC input;
153-002 220-240VAC input
4.2 Gradient Forming Accessories
2 cannula 1 bubble level
4.2.1 Tube Holders: (each tube holder is shipped with a marker block and 6 or 12 caps, I, R or IR)
105-925-I, R or IR: 25 mm SW28 tube holder
105-916-I, R or IR: 25 mm SW28.1 tube holder
105-914A-I, R or IR: 25 mm SW41 tube holder
105-914B-I, R or IR: 25 mm SW40 tube holder
105-913-I, R or IR: 25 mm SW50 tube holder
105-911A-I, R or IR: 25 mm SW60 tube holder
105-911B-I, R or IR: 25 mm TLS55 tube holder
(8-place tube holders are available for quick seal vertical rotor tubes,but they cannot be fractionated with this device)
4.3 Gradient Fractionation
Includes the following accessories:
1 Manual 1 Left wing for extended working area
1 60 cc syringe rinse reservoir 1 Front panel keypad/LCD display/computer
4 feet 1 Fraction collector advance cable
1 Set of 6 Allen Wrenches, 1 Phillips screw driver
8 Spare check balls and 2 sizes of orings 1 Tubing terminator
1 Cursor for each tube holder 2 sets of assembly screws for computer panel and wings
1 Spare light bulb 1 Water level adjust cannula w/stop
1 Spare valve assembly 1 power cord
1 valve cleaning needle 1 12VDC 6.6A transformer
1 m of spare Teflon tubing 1 SD card with pdf manual and backup files
1 fine marker 1 SD card reader with USB cable
1 fine marker 1 SD LEXAR card reader with USB cable
To Next Page
Loading...