A
Charging your smartdot™ transmitter
1. Connect smartdot™ transmitter to the supplied USB cable.
2. Connect the cable to a powered USB wall charger.
3. The transmitter will display a blinking blue light to indicate that it
is charging. A full charge can take up to 2 hours to complete.
4. When the transmitter is fully charged, the blinking blue light will
disappear, and no light is shown.
5. Remove the charging cable. smartdot™ transmitter is now ready to
be paired.
You must charge your transmitter before using it for the rst time.
The smartdot™ transmitter will automatically switch on when you plug in
the USB cable.
After initial charging, your transmitter will need to be recharged
approximately every 2 weeks.
Do not use smartdot™ transmitter while it is charging.
2h
Part 5 Preparing
8
To Next Page
Loading...