1. Prepare your pen injector, as shown in the pen instructions for use. Respect
the acclimatation time specied in the pen instructions before use.
2. Turn the smartdot™ dial wheel until your intended dose is visible in the dose
window.
3. Perform your injection as described in the pen instructions for use.
4. Remove the needle from your skin and then release the injection button. The
green light will stay for few seconds.
Note:
Your smartdot™ transmitter does not change the injection process for your
pen injector. Please follow the pen instructions for use to prepare and perform
your injection. The steps below only cover the use of smartdot™ transmitter.
The green light will show when injection button is pressed, it means that the
transmitter is ready to record the injection. During injection, the green light
shown means that the injection data is being measured.
Do not watch the green light during injection, it does not indicate how to
inject. Always follow the pen injection steps.
Part 6 Injecting
IMPORTANT:
Before removing the pen injector from the skin, make sure the number “0.0”
appears in the dose window to ensure you injected the full dose.
Note:
Contact your healthcare professional if you have questions about your pen
injector or if you are unsure you have injected your prescribed dose.
If you have any doubts about the synchronization of the data with the
application or with the data displayed please contact your healthcare
professional.
13
To Next Page
Loading...