How do I check the status of my smartdot™ transmitter?
Once smartdot™ transmitter has been connected to the
App, you can press the injection button at any time. This
will wake up the transmitter and a light will switch on for
few seconds. This light can be green, orange or red. See
‘Part 9: Troubleshooting guide’ if you see a red or orange
light, or no light at all.
Do not play with your pen injector or smartdot™ trans-
mitter. Only dial your dose when you are about to perform
an injection.
How do I take care of my smartdot™ transmitter?
• Attached to the pen injector – to wipe the external surfaces
• Removed from the pen injector – to wipe the internal surfaces. In
this case, you need to deactivate smartdot™ before removing it
from the pen. See ‘Part 8: Frequently Asked Questions <C. How
do I deactivate and remove the smartdot™ transmitter?’.
Do not wipe smartdot™ transmitter while it is connected to external
power source. Unplug the transmitter before wiping it.
Do not immerse smartdot™ transmitter in water. It is not waterproof,
and you may damage the transmitter.
Do not leave your smartdot™ transmitter or its accessories in a dusty
location.
Do not use any cleaning solutions, chemicals or alcohol wipes.
You can wipe your transmitter with a clean damp cloth whenever need-
ed, when it is:
If you removed smartdot™ transmitter from the pen:
1. Place your transmitter back on your pen. See ‘Part 5: Preparing <D.
Placing smartdot™ on your pen injector’.
2. Reactivate your transmitter. See ‘Part 5: Preparing <E. Activating
your smartdot™ transmitter’.
Part 8 Frequently asked questions
A
B
17
To Next Page
Loading...