Biolight Q3 - Page 104

Patient Monitor User’s manual
12-4
Select the alarm source for IBP parameters. When the selected parameter or
one of the parameter exceed alarm limit, the monitor will give out alarm
signal. The options are as follows:
【Sys】:Only Systolic pressure exceeds the alarm limit will trigger the alarm
system.
【Dia】:Only Diastolic pressure exceeds the alarm limit will trigger the alarm
system.
【Mean】:Only Mean pressure exceeds the alarm limit will trigger the alarm
system.
【Sys&Mean】:Systolic pressure or mean pressure exceeds the alarm limit
will trigger the alarm system.
【Mean&Dia】:Mean pressure or diastolic pressure exceeds the alarm limit
will trigger the alarm system.
【Sys&Dia】:Systolic pressure or diastolic pressure exceeds the alarm limit
will trigger the alarm system.
【Sys&Dia&Mean】:Mean pressure, systolic pressure or diastolic pressure
exceeds the alarm limit will trigger the alarm system.
 Setting Unit
Select IBP parameter area, and select【Unit】in the IBP setting menu, and
the options are【mmHg】,【kPa】or【cmH
2
O】.
 Setting Display Format
Select【Display Format】in the IBP setting menu, and the options are 【S/D
M】,【S/D】,【Mean】or【M S/D】.
12.5.2 Setting IBP Waveform
Select IBP waveform area, and enter the IBP waveform setting menu.
 Setting Wave Speed
Select【Wave Speed】in the IBP waveform setting menu, and select the
wave speed in the options as required.
 Setting Wave Scale