To Next PageTo Next Page
Need help?Do you have a question about the Biolight Q7 and is the answer not in the manual?
General| Brand | Biolight |
|---|---|
| Model | Q7 |
| Category | Medical Equipment |
| Language | English |
Information about the manufacturer, address, and contact methods.
Details about manual updates and revision versions.
Explains the manual's purpose, scope, and target audience.
Defines symbols, formatting, and abbreviations used in the manual.
Specifies the intended use, application, and limitations of the patient monitor.
Describes the physical layout and components of the patient monitor.
Crucial warnings and precautions for safe operation and patient care.
General safety guidelines for installation, environment, and electrical safety.
Steps for initial setup, starting monitoring, and basic operations.
Explains the monitor's display layout and how to navigate using smartkeys.
Classifies alarms by type and severity, and how they are signaled.
How to adjust alarm volume, set parameters, pause, and acknowledge alarms.
Critical safety warnings and steps for ECG monitoring, including electrode placement.
Configuration options for ECG modes, leads, gain, and ST/Arrhythmia analysis.
Safety warnings and steps for respiration rate monitoring, including electrode placement.
Critical safety warnings for SpO2 sensor usage and potential interference.
Steps for SpO2 sensor application and configuration options.
Safety warnings and steps for temperature probe selection and monitoring.
Critical safety warnings for NIBP measurement, patient types, and cuff selection.
Steps for NIBP measurement preparation and configuration options.
Safety warnings and steps for IBP monitoring, including system setup.
Procedure for zeroing the IBP transducer to ensure accurate pressure readings.
Procedures for CO2 monitoring and essential sensor zeroing steps.
Procedures for AG monitoring and critical safety warnings for module use.
How to freeze, review, and release waveforms for detailed patient observation.
How to review graphic trends, tabular data, NIBP results, and alarm events.
Procedures for calculating drug dosages and hemodynamic parameters.
How to use nurse call functionality and output analog signals.
How to configure and operate the monitor's thermal recorder, including paper installation.
Steps for installing, charging, optimizing, and disposing of the monitor's battery.
Schedule and procedures for periodic maintenance and safety checks.
Guidelines for cleaning the monitor, sensors, and accessories safely.
Lists available accessories for various monitoring parameters.
Details safety classifications and environmental operating conditions.
Technical details of display, recorder, battery, and measurement parameters.
Lists default settings for system, interface, alarm, and recorder.
Default settings for ECG, SpO2, NIBP, and other monitored parameters.
Lists causes and levels for all system and parameter alarm messages.
Guidance on electromagnetic compatibility, emissions, immunity, and RF separation distances.
