Patient monitor User’s manual
21-2
Limit: type BF: for a.c.: 100μA, for d.c.: 10μA.
type CF: for a.c.: 10μA, for d.c.: 10μA.
⑨ Test the patient leakage current under single fault condition according IEC
60601-1:
Limit: type BF: for a.c.: 500μA, for d.c.: 50μA.
type CF: for a.c.: 50μA, for d.c.: 50μA.
⑩ Test the patient leakage current Mains voltage on applied part: According
IEC 60601-1:
Limit: type BF: for a.c.: 5mA.
type CF: for a.c.: 50uA
Warning: No use-serviceable parts inside, before servicing to
authorized representative or manufacturer.
Note: We will make available on request circuit diagrams, component
part lists, descriptions, calibration instructions, or other
information which will assist the user’s appropriately qualified
technical personnel to repair those parts of equipment which
are designated by the manufacturer as repairable.
21.2 Equipment Cleaning
Keep your equipment and accessories free of dust and dirt. To avoid damage
to the equipment, follow these rules:
1. Always dilute according the manufacturer’s instructions or use lowest
possible concentration.
2. Do not immerse part of the equipment in the liquid.
3. Do not pour liquid onto the equipment or accessories.
4. Do not allow liquid to enter the case.
5. Never use abrasive materials (such as steel wool or silver polish), or erosive
cleaners (such as acetone or acetone-based cleaners).
Warning: Be sure to shut down the system and disconnect all power
cables from the outlets before cleaning the equipment.
To Next Page
Loading...
Need help?
General
