Patient monitor User’s manual
21-3
Caution: If you spill liquid onto the equipment or accessories, contact
us or your service personnel.
21.3 Cleaning of the Monitor
 Common detergent and non-corrosive disinfectant used in hospital can be
applied to clean monitor, however you must be aware that many kinds of
detergents must be diluted prior to utilization, and please use it according to the
instruction of detergent manufacturer.
 Avoid the use of alcohols, amino or acetonyl detergent.
 The enclosure and screen of monitor shall be free of dust, and they can be
wiped with lint-free soft cloth or sponge soaked in detergent. While cleaning,
be careful and do not spill liquid onto the instrument and keep any liquid out of
it. When wiping the side panel of monitor, you must be especially careful to
keep water out of all kinds of cable and outlet on the panel.
 Do not use abrasive material including wire brush or metal brightener during
cleaning because this material will damage the panel and monitor screen.
 Do not submerge the monitor in liquid.
 While cable or plug of attachment accidentally gets wet, please rinse it with
distilled water or deionized water and dry it in the environment of temperature
40℃ to 80℃ for at least one hour.
21.4 Cleaning and Sterilizing of Accessories
1． ECG cable
The recommended disinfectors include glutaric dialdehyde solution and 10%
decolourant solution.
a) Please clean cable prior to sterilization.
b) Clean the cable surface with soft cloth bedewed with some fresh water or
neutral soapy water.
c) Scrub cable with soft cloth bedewed with some disinfector.
d) Wipe off the disinfector remaining on cable by soft cloth bedewed with fresh
water.
e) Put cable in a shady and cool environment for airing.
Attention:
To Next Page
Loading...
Need help?
General
