Patient monitor User’s manual
21-4
Do not sterilize lead wire with high-pressure, radioactive or steam device.
Do not directly submerge lead wire in liquid.
To avoid long-time harm to cable, it is suggested that sterilization to the
product be conducted only when necessary according to the regulation of your
hospital.
Do not clean and reuse disposable electrode.
2． SpO
2
Sensor
The recommended disinfector include: isopropyl alcohol 70%, 10%
decolourant solution can be used for sterilization at lower standard. Don’t use
undiluted decolourant (5% ～ 5.25% sodium hypochlorite) or other
non-recommended disinfector in order to avoid damage to sensor.
The method of cleaning and sterilization can refer to the corresponding
method of ECG cable.
Attention:
Do not immerse the sensor in water, solvents, or cleaning solutions (the
sensors and connectors are not waterproof).
Do not sterilize by irradiation, steam, or ethylene oxide.
Do not directly submerge sensor in any liquid.
To avoid long-time harm to sensor, it is suggested that sterilization to the
product is conducted only when necessary according to the regulation of
your hospital.
3． Temp Sensor
The recommended disinfector: 70% isopropyl alcohol solution, glutaric
dialdehyde solution and 10% decolourant solution.
The method of cleaning and sterilization can refer to the corresponding
method of ECG cable.
Attention:
Do not repeatedly sterilize and use disposal temperature sensor.
To avoid long-time harm to sensor, it is suggested that sterilization to the
product be conducted only when necessary according to the regulation of
your hospital.
Temp sensor can only withstand 80～100 temperature for a short time℃
and the heating temperature is not allowed to surpass 100 .℃
4． NIBP Cuff
To Next Page
Loading...
Need help?
General
