Patient Monitor User’s manual
4-1
Chapter 4 User Interface
4.1 Display Style
Display style of user interface can be set according to your need.
Including:
——Sweep mode of wave;
——Screen brightness:
——Display color of wave and parameter:
——Parameter and wave to be monitored.
4.1.1 Sweep Mode
1. Select【Main Menu】smartkey→【Screen Setup】;
2. Set【Sweep Mode】to【Refresh】or【Scroll】:
【Refresh】: The waveform is still, refreshing from left to right.
【Scroll】: The waveform scrolls from right to left.
4.1.2 Screen Brightness
1. Select【Main Menu】smartkey→【Brightness】or select【Brightness】
smartkey;
2. You can set the screen brightness to a value between 1 and 10. 1 is the
minimum brightness and 10 is the maximum.
4.1.3 Parameter Color
1. Select【Main Menu】smartkey→【Screen Setup】;
2. Select【Parameter Color Setup】, click the color block of corresponding
parameter, and then select the color according to your need from the popped
menu.
4.1.4 Selecting Parameter
You can select the parameters to be displayed according to the requirement
of monitoring and measurement.