To clear any buttons or directions attached to the M1 or M2
buttons, follow these steps:
1. Press and hold the Program button for five seconds. The
second and third player indicator LEDs will flash.
2. Press either the M1 or M2 buttons.
a. If the M1 button is pressed, only the third player indicator
LED will continue to flash.
b. If the M2 button is pressed, only the second player
indicator LED will continue to flash.
3. Press the Program button. This will clear any button or
direction attached.
NOTE: You can also clear both M1 and M2 buttons
simultaneously by holding down the Program button for eight
seconds.
TURBO MODE
Turbo can be used on the following buttons: A / B / X / Y / L /
R / ZL / ZR.
There are 2 types of Turbo mode: Regular Turbo and Super
Turbo. Here are the steps turn on each type:
1. Press and hold the Turbo button, then press an action
button that you want to set up in turbo mode.
2. Press and hold the Turbo button, then press the same
action button again to get into Super Turbo mode.
3. To turn o turbo mode, press and hold the Turbo button,
then press the same action button.
NOTES:
• When an action button is in Super Turbo mode, it will
continuously be in use until the mode is turned o.
• Press and hold the Turbo button for 10 seconds to clear all
the current turbo functions.
• Multiple buttons can be activated simultaneously.
VIBRATION MODE
To adjust the intensity of the vibration on the controller, press
the Vibration button. Each press changes the vibration
intensity. You can choose between O, 30%, 70% and 100%.
NOTES:
• When using the controller on a Nintendo Switch®, go to
System Settings, click on Controllers and Sensors and under
Controller Vibration, make sure the option is On.
• Vibration only works on some games. Please check the
5
To Next Page
